Output Module, 12/24VDC, 0.75A, 32-Point Grouped, with ESCP
The IC694MDL754 is a 12/24 volt DC, ESCP 0.75A Positive Logic Output module, providing 32 discrete outputs in two isolated groups of 16. Each group has its own common. The outputs are positive logic or sourcing-type outputs, switching loads on the positive side of the power supply and supplying current to the load. Each point features electronic overcurrent/short circuit protection and generates an individual fault if either condition exists. In addition to output driver faults sent back to the RX3i controller, the module provides various fault indications including loss of field side power fault, ESCP point failure within a group, field terminal block ON/OFF status, and DIP switch configuration mismatch fault.
Module Features:
Isolation:
Field to Backplane (optical) and to Frame Ground: 250 VAC continuous; 1500 VAC for 1 minute
Group to Group: 250 VAC continuous; 1500 VAC for 1 minute
Module ID: 0x059h
Output Current: 0.75 Amps per point
Power Consumption: 300 mA (maximum) from 5 volt bus on backplane
Thermal Derating: No derating at 24VDC. At 30VDC, outputs are derated above 42 degrees C
External Power Supply: +12 VDC to +30 VDC, 12/24 VDC nominal
Output Characteristics:
Inrush Current: 3 Amps supplied for 10ms without ESCP trip
Output Voltage Drop: 0.3 volt DC maximum
Steady-state Overcurrent Trip: 5 Amps typical per point
Output Leakage Current: 0.1mA maximum
On Response Time: 0.5ms maximum
Off Response Time: 0.5ms maximum
Protection: Short-circuit protection, overcurrent protection, overtemperature protection, all with auto recovery.
